How do you scrape old Thinset?
Hammer your 1 in (2.5 cm) putty knife at a 45-degree angle to the thinset. You can also use a masonry chisel that is the same width. Continue removing the thinset in small chunks until you’ve removed enough to accommodate your new tiles. Always use a putty knife with a hammer-end handle and sharp blade. Click to see full answer. Regarding this, do I have to remove thinset before laying laminate?You can put tile over old thinset. Make sure it not loose, vacuum to remove any debris, check for cracks, apply membrane if needed. Remove the old thinset to get a flat surface for wood or laminate installation.Secondly, how do you clean Thinset? How to Clean Up Thinset Mortar Wipe the areas down with a sponge and some clean water. Substitute vinegar for water if you have a thicker layer of thinset on the face of the tile. Apply a straight solution of grout cleaner for the thickest areas of thinset mortar marring the surface of your installation, and scrub it with a scrub brush. Consequently, how do you smooth out Thinset? Follow the manufacturer’s instructions and start with a coarse-grit sandpaper of 24- to 80-grit. Wipe away or vacuum up the dust before installing your tile. Go over the area again with 80- to 100-grit sandpaper if you will be painting the thinset. Clean it thoroughly of all dust so that your paint will dry smoothly.Does wetting Thinset make it easier to remove?Wet the thinset before chipping it off to just about eliminate any dust. It also makes the thinset much easier to remove. (at least most of the common thinsets used) The longer you can let the thinset soak, the better.
ncG1vNJzZmivp6x7pLHLnpmroaSesrSu1LOxZ5ufonuotI6hprBllKR6urvUZqqcqpGlsm67y51kraCZo8CmwI4%3D